Circuit Analysis – Week #2 Lab.
Help me study for my Engineering class. I’m stuck and don’t understand.
Circuit Analysis – Week #2 Lab Circuit Analysis Techniques in Multisim
This week’s lab is based on the application of circuit analysis techniques to a resistive circuit in Multisim. You will learn to utilize Multisim to perform the mesh analysis.
1. Using the circuit below, determine the current ‘i1’ and power supplied by 1V source.
2. Redo the problem, this time without the dependent current source ‘5i1’. 3. Fill in the calculated values in the table below:
Calculated current ‘i1’
Calculated Power supplied by 1V
Measured Current ‘i1’
Measured Power supplied by 1V
With Dependent Source (5i1)
Without Dependent Source (5i1)
4. Construct the circuit in the above in Multisim. a. Run the simulation to measure the current ‘i1’ and power supplied by 1V source record the measurements in the table. (Use 5% tolerances for each of the resistors) b. Next, remove the dependent source ‘5i1’ from the circuit and run the simulation again to record the measurements in the table. (Use 5% tolerances for each